I’m not having any Googling luck trying to fix my problem.
I received a request from my neighbors for a name sign to hang on the stall of a new horse. This will be the 3rd sign that I’ve done for them. I just copied and changed the horse’s name on an older file that had previously ran successfully.
Using Aspire 8.5 and a Camaster Stinger.
Aspire job dimensions were set for the new board thickness (~.1 inch thicker). Everything recalculated and tap files saved. The Aspire Preview looked correct, the images of a horse with a barbed wire border were inset like I had intended.
Camaster touch top calculations were right on, paper in between the work and the bit just catches. Tried zeroing it manually anyway.
Tried both the single tool post processor and ATC post processor. Even tried an edited pp from a few years back that had had a Y axis glitch.
When I run the first file that begins the rough out for the inset images, the bit doesn’t go down into the wood at all. It remains slightly above the work surface.
I’d be very grateful if someone could point me in the right direction. It’s been a couple of years and an Aspire upgrade since I last did a full project beyond checking, oiling and making sure the machines were functioning. Can the measure tool length process glitch things even though Z0 looks good?
Thanks for any help.
Sorry for the mixed up title, something to do with my ipad I imagine. Is there a way to edit the title?